Muros de Bloque MálagaBlock walls, split-face & concrete panels
Panel (slats / mesh)Strip footingLow wall (murete)PillarPanel (slats / mesh)Ground
Guide · Slopes

Building block walls on sloping plots

Málaga's hills make level plots the exception. A wall on a slope can look neat and stay sound, as long as the steps, footings and levels are planned from the start.

Technical guidesLast reviewed: Bauman Raymond Attila

Which kind of slope do you have?

In short: a slope along the wall line can usually be handled by stepping; a level difference across the line (higher on one side) may turn the wall into a retaining wall.

Two situations look similar but are very different:

  • Slope along the line. The ground rises or falls as you walk along the wall, but both sides are at about the same level at any point. This is a design question: the wall steps.
  • Level difference across the line. One side of the wall is higher than the other. The wall may be holding back soil, which makes it a retaining structure. See garden wall or retaining wall.

Many plots have both. We start every sloping job by walking the line and noting where each situation applies.

How is the footing built on a slope?

In short: the footing is built in level steps rather than sloping, so each section sits flat on the ground beneath it.

A footing should sit on level ground. On a slope, that means building it in steps: level sections joined by vertical risers, following the fall of the land. Each step has to overlap and connect properly with the next, and the reinforcement has to run through the changes of level.

The size of each step depends on the slope and on the block module, since the courses above have to line up. That is why setting out on a slope takes longer than on flat ground. Our foundations guide explains the footing in general.

Should the wall step or follow the slope?

In short: block walls normally step in level sections; the top of the wall and the caps can step with them or be arranged to give a smoother line.

Block courses are laid level, so the wall naturally steps with the footing. The visual question is how the top of the wall behaves:

  • Stepped top. Each section is level and steps down at the pillars. This is the most common and usually the neatest look.
  • Constant height. The wall stays the same height above ground in each section, so the steps follow the slope.
  • Level top over a run. Possible on gentle slopes, but the wall gets taller as the ground falls, which affects rules on height and the footing.

Pillars are the natural place for the steps. On a low wall with pillars, the infill can then be fitted level between them.

How does an infill work on a sloping wall?

In short: infill sections are usually fitted level between pillars, with the step taken at each pillar; some systems can also be raked to follow the slope.

Most slat and panel systems are designed to be fitted level. On a stepped wall, each section between pillars is fitted level and the change of height happens at the pillar. That keeps lines clean and avoids awkward cuts.

Some mesh and board systems can be fitted on a rake, following the slope. If you have a particular product in mind, tell us before we set out, so the pillars and steps match. See the page on a low wall with a fence on top for how we coordinate wall and infill.

Why is water more of an issue on slopes?

In short: rainwater runs downhill along and against the wall, so drainage and the base detail matter more than on level ground.

On a slope, runoff concentrates. Water flowing along the base of a wall erodes the ground beside the footing, stains the masonry and, if it gets behind the wall, adds pressure. Simple measures help: keeping garden soil below the base of the wall, leaving gaps or channels where water would otherwise pond, and directing downpipes away from the wall line.

Where a wall would block a natural flow of water across the plot, plan how that water will pass. If a public stream or channel is nearby, special rules may apply (check with the relevant authority).

Do height rules apply differently on slopes?

In short: height limits are usually measured from the ground, so on a slope the way heights are measured matters; ask the ayuntamiento how they measure it.

Towns usually limit wall heights measured from ground level. On a slope, the ground level is different at each point, and towns may measure from the natural ground, from the finished ground or from the street. The rule varies (check with your ayuntamiento).

Ask how heights are measured before designing a stepped wall, especially on a street front. Our permits guide lists the questions to bring to the town hall.

BR
Bauman Raymond Attila
Author and person responsible · Last reviewed:
FAQ

Frequently asked questions

Can a block wall be built on a steep slope?

Yes, by stepping the footing and the wall. If the slope creates a level difference across the line, a technician must check for retaining issues.

Does the footing slope with the ground?

No. It is built in level steps connected to each other.

Where should the steps go?

Usually at pillars, which hides the change of level and suits most infills.

Can the infill stay level on a slope?

Yes, between pillars. The step happens at each pillar.

Is a wall on a slope more expensive?

Usually it takes more labour, because setting out, excavation and block cutting are more complex.

What if my garden is higher than the neighbour's?

Then the wall may retain soil. A technician should assess that before building.

How do I stop water undermining the wall?

Keep soil below the base, avoid aiming irrigation at it and give runoff a way through or around.

Can precast concrete panels be used on slopes?

Yes, stepped at the posts, or on a stepped block base.

How is wall height measured on a slope?

It depends on the town. Ask the ayuntamiento how they measure height on sloping ground.

Can you assess a sloping plot from photos?

We can make a first assessment from photos and approximate lengths, but slopes need a site visit before a final quote.

Get a quote

Planning a block wall? Send us photos

Send photos and the approximate length of your boundary. We reply with questions or a first itemised assessment, without commitment.